Part I
Part I
1 - 45 Nm
2 - Engine bracket
3 - 25 Nm
4 - Bracket
- Depending on version
5 - Bracket
6 - Hose clip
7 - 10 Nm
- For engine cover
- Depending on version
8 - 20 Nm
- Depending on version
9 - Toothed belt guard, upper part
10 - Toothed belt guard, center section
11 - 20 Nm
12 - Washer
13 - Tensioning roller
- Checking semi-automatic toothed belt tensioning roller. Refer to Semi-automatic toothed belt tensioning roller, checking
14 - Toothed belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing and installing, tensioning. Refer to Engine codes AEG, AVH, AZG, BEV .
15 - Rear toothed belt guard
16 - Washer
- Note Part No.
17 - O-ring
- Always replace
18 - Coolant pump
- Check for ease of movement
- If damaged or leaking replace complete
- Removing and installing. Refer to Coolant pump, removing and installing
19 - 15 Nm
20 - Crankshaft toothed belt sprocket
21 - 90 Nm plus 1/4 turn (90 ° )
- Always replace
- Threads and shoulder must be free of oil and grease
- Use counterhold tool 3415 to loosen and tighten
22 - Toothed belt guard, lower part
23 - 10 Nm
- Always replace
24 - Electro-magnetic coupling
- Air conditioning compressor
25 - Belt pulley
- For power steering pump
26 - Poly V-belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing and installing. Refer to Poly V-belt, removing and installing
27 - Belt pulley/vibration damper
- Can only be installed in one position; holes are offset
- Note position when installing toothed belt. Refer to Engine codes AEG, AVH, AZG, BEV
28 - 25 Nm
29 - Tensioning element for poly V- belt
- Turn with open end wrench to loosen ribbed poly V-belt. Refer to Poly V-belt, removing and installing