Reverse Shaft: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Thrust TubeVW 454
Thrust PadVW 447 H
PunchVW 411
Centering Mandrel 12 - 551
Thrust PlaceVW 401
PunchVW 408 A
Kukko Extractor 14.5-18.5 mm21/2
Kukko Support22/1

NOTE:

Always replace the needle sleeve after removing it from the clutch housing or from the reverse shaft support.

Fig 1: Clutch Housing Remove/Install Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Clutch Housing
Needle Sleeve
- Removing, refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing, refer to Installing the Needle Sleeve -A- into the Clutch Housing .
Reverse Gear
Lock Ring
- Always replace after removing.
Reverse Gear
- Remove before replacing the lock ring.
- Collar faces reverse gear.
Reverse Shaft
- Removing, refer to TRANSMISSION .
Needle Sleeve
- Removing, refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing, refer to Installing the Needle Sleeve into the Reverse Shaft Support .
Reverse Shaft Support
- Removing and installing, refer to TRANSMISSION .