Lubrication system components, removing and installing
NOTE:
- If when repairing an engine, metal shavings or large amounts of small metal particles are found in the engine oil, caused for example by partial seizure of crankshaft or connecting rod bearings, perform the following work sequences to prevent consequential damage once repairs are complete:
- Thoroughly clean oil passages
- Replace oil spray jets
- Replace oil cooler
- Replace oil filter
- The oil level must not be above the Max. mark or there is a danger of damage to the catalytic converter!
- Markings. See Figure .
Checking oil pressure and oil pressure switch. Refer to Oil pressure and oil pressure switch, checking .
Oil system capacity
Refer to Additional Information, Fluid Capacity Chart
Engine oil specifications
Use engine oils according to VW standard 500 00, 501 01 or 502 00. Multigrade and single grade oils conforming with API-SF and SG or ACEA A2/A3 may also be used if oil to VW standard is not available.
NOTE:
- In the factory the engine is filled with engine oil conforming to VW standard 503 00. This engine oil is designed for long service intervals.
- Engine oils according to VW standard 500 00, 501 01 or 502 00 can be used.