Filler Tube

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Turn off the ignition and all electrical consumers.
Remove the key.

Removal

-- Remove the connecting pipe -1- from the filler tube -3- on the container.

Fig 1: Identifying Filler Tube For Tank For Windshield Washer System And Headlamp Cleaning System Remove/Install Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bolt -2-.

-- Unclip the hose bracket from the filler tube -3- and remove it from the vehicle.

Installation

Installation is performed in the reverse order of removal. Note the following:

The casting mark on the bottom side of the filler tube must be inserted into the hole -arrow-.

Fig 2: Identifying Casting Mark On Under Side Of Filler Tube And Engine Mounting Hole

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Connecting tube -1- and filler tube -2- must be joined so that the guides -arrows- engage in each other.

Fig 3: Identifying Connecting Tube And Filler Tube Joined So That The Guides Engage In Each Other

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.