Seat adjustment, initiating On Board Diagnostic (OBD)

Test prerequisites:

Voltage supply and fuses for the respective system OK.
To initiate the On Board Diagnostic (OBD) the ignition must be switched on "Terminal 15 on".

NOTE:

If the display remains blank, check V.A.G 1551 voltage supply according to wiring diagram.

Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations

Additional operating information can be printed out depending on the program by pressing the HELP button of V.A.G 1551.
The → button is used for advancing the program sequence.
The PRINT button is used for switching on the printer (warning lamp in button lights up).
Connecting scan tool. Refer to Scan tool, connecting

Indicated on display:

Rapid data transfer HELP
Enter address word XX

Address word for the seat adjustment: 36

Indicated on display:

Rapid data transfer HELP
Enter address word XX

Indicated on display after entering the address word 36:

Rapid data transfer Q
36 Seat adjustment

and then the following appears in the display:

Indicated on display:

Rapid data transfer
Tester sends the address word 36

The control module identification will be shown on the V.A.G 1551 scan tool display, e.g.:

3B1959760XX Seat adjustment FS 0001 →

Indicated on display:

Rapid data transfer HELP
Select function XX