Check Control Module Version
- Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Seat adjustment, initiating On Board Diagnostic (OBD) .
- Switch on ignition.
- Press button -1- for "Rapid data transfer" mode.
- Switch on printer with Print button (warning lamp in button lights up).
- Press buttons -0- and -1-.
Indicated on display:
| Rapid data transfer Q 01-Check Control Module Version |
- Confirm entry with the -Q- button.
The control module identification will be shown on the V.A.G 1551 scan tool display, e.g.:
| 3B1959760XX Seat adjustment FS 0001 → |
Breakdown of the display:
- Part No. of control module, System designation (XX seat adjustment DS 0001)
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If one of the malfunction messages opposite appears in the display, the possible causes of the malfunction can be printed out with the HELP button.
- Ignition must be switched on.
- Malfunctions have occurred at the start of or during the program (external interference?).
- Check diagnosis wires as well as voltage supply and Ground connection.
- Press buttons -0- and -6- to end the output.
Indicated on display:
| Rapid data transfer Q 06 End output |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Switch off ignition.
- Disconnect connector to V.A.G 1551 scan tool.