Central locking control module, coding

• Connecting scan tool. Refer to Scan tool, connecting  . Initiating On Board Diagnostic (OBD). Refer to Convenience system, initiating On Board Diagnostic (OBD)  .

Indicated on display:

Rapid data transfer HELP Select function XX

• Press buttons -0- and -7- (with 07 the function "Code control module" is selected).

Indicated on display:

Rapid data transfer Q 07 Code control module

• Confirm entry with the -Q- button.

Indicated on display:

Code control module Q Enter code number XXXXX (0-32000)

- Enter code number according to table:

Address word	Code number
Vehicle equipment	2 doors	4 doors
35 Central Locking
Manual windows, one door	00256	04096
35 Central Locking
Manual windows, all doors	00257	04097

Address word	Code number
Vehicle equipment	2 doors	4 doors
35 Central Locking
Manual windows, one door	00016	00018
35 Central Locking
Manual windows, all doors	00017	00019

• Confirm entry with the Q button.

The control module identification number will be displayed with the corresponding letter index, the code number and the workshop code.

1C0962258 XX Cent. Lock. 00001 → Coding XXXXX WSC XXXXX

If the contents of the display are as shown then the coding is successful.

If the code number entered is not accepted by the control module, the previous coding will appear in the display:

Indicated on display:

1C0962258 XX Cent. Lock 00001 → Coding XXXXX WSC XXXXX

In this case the control module has not been programmed with the relevant data for the vehicle. A check must then be completed to see if the correct control module for the vehicle has been installed (compare Part No. and letter index), or whether an incorrect code number has been entered.

• Repeat coding.

If the control module cannot be coded (correct control module, correct code number), the control module is malfunctioning.

Ending function:

• Press → button.

Indicated on display:

Rapid data transfer HELP Select function XX

• Press buttons -0- and -6- to end the output.
• Confirm entry with the -Q- button.

Indicated on display:

Rapid data transfer Q 06 End output

• Switch off ignition.
• Disconnect connector to V.A.G 1551 scan tool.