Introducing On Board Diagnostic (OBD) for airbag
- Connecting scan tool. Refer to Scan tool, connecting .
- Switch on printer with Print button (warning lamp in button lights up).
- Switch on ignition.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Press buttons -1- and -5- (the address word of the vehicle system to be tested "Airbag" is entered with 15).
Indicated on display:
| Rapid data transfer Q 15 Airbag |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If one of the malfunction messages opposite appears in the display, the possible causes of the malfunction can be printed out with the HELP button.
- Ignition must be switched on.
- Malfunctions have occurred at the start of or during the program (external interference?).
NOTE:
- Check diagnosis wires as well as voltage supply and Ground connection.
- After repairing the possible causes of the fault, once again enter the address word 15 for "Airbag" by pressing -1- and -5- buttons and confirm with the -Q- button.
Indicated in display after entering the address word 15:
| Rapid data transfer Tester sends the address word 15 |
and then the following appears in the display:
Indicated on display (see parts catalog for latest control module version).
| 1J0 909 608 D AIRBAG VW 3-S V03 → Coding 00068 WSC12345 |
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |