LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (2.0L - Cooling System - Engine Code(S): BPY) >> 19 Cooling System >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different variant/trim than selected.
Component Fastener Size Nm
Connecting Piece to Cylinder Head Bolt - 10
Coolant Expansion Tank to Body Stud Bolt - 5
Coolant Fan to Fan Shroud Nut - 5
Coolant Pipe to Coolant Thermostat Housing Bolt - 5
Coolant Pipe to Cylinder Head Bolt (1)
  - 30
- 40
Coolant Pipe to Oil Cooler Bracket Bolt - 5
Coolant Pump to Cylinder Block Bolt - 15
Coolant Recirculation Pump to Bracket Bolt - 8
Coolant Recirculation Pump Pipe Bracket Nut 2, 3
  - 3
- 5
Coolant Thermostat Housing to Cylinder Block Bolt - 15
Fan Shroud to Radiator Bolt - 5
Radiator Bolt - 5
Toothed Belt Guard to Cylinder Block Bolt (4) - 10
(1) For bolt tightening clarification, see -items 1 and 2- in the COOLING SYSTEM COMPONENTS OVERVIEW, ENGINE SIDE .
(2) For nut tightening clarification, see -items 1 and 7- in the Coolant Recirculation Pump -V50- OVERVIEW, WITH A BYPASS THERMOSTAT .
(3) For nut tightening clarification, see -items 1 and 10- in the Coolant Recirculation Pump -V50- OVERVIEW, WITHOUT A BYPASS THERMOSTAT 
(4) Install using locking fluid.
scientia non olet · About LEMON Manuals