Coolant Fan And Coolant Fan 2

WARNING: This page is about a different variant/trim than selected.

Removing

-- Remove the upper fan shroud bolts -upper arrows-. Loosen the refrigerant pipes and move them to the side if necessary.

Fig 1: Disconnecting Electrical Harness Connector And Removing Mounting Bolts Of Intake Air Elbow

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove the noise insulation. Refer to Description and Operation .

-- Disconnect the harness connector -1- and remove the lower fan shroud bolts -lower arrows-.

Fig 2: Disconnecting Electrical Harness Connector And Removing Mounting Bolts Of Intake Air Elbow

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove the fan shroud downward.

-- Disconnect the electrical harness connector -1- and lay the wire to the side.

Fig 3: Disconnecting Electrical Harness Connector And Lay Cable Free

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove the nuts -arrows- and remove the coolant fans.

Installing

Install in reverse the order of removal. Note the following: