Seal, Between The Transmission And Bevel Box, Transmission Side

Special tools and workshop equipment required 

• Pulling Hook -T20143-
• Use Oil Collecting and Extracting Device -V.A.G 1782-
• Thrust Piece -T10243-

Removing 

-- Remove the bevel box. Refer to BEVEL BOX .

Place the used oil collecting and extracting device -V.A.G 1782- under the transmission.

-- Pry out the seal from the transmission using the pulling hook -T20143/1- or -T20143/2-.

Installing 

-- Fill the area between the sealing lip and dust lip -arrow- halfway with sealing grease fro seal -G 052 128 A1-.

Fig 1: Identifying Oil Seals Sealing Lips

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Lightly lubricate the outer circumference of the seal.

-- Carefully install the seal all the way using the thrust piece -T10243-.

Fig 2: Identifying Sealing Ring Carefully Driven In As Far As Stop Using Thrust Piece T10243

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Install the bevel box. Refer to BEVEL BOX .

-- Check the gear oil level in the bevel box and fill, if necessary. Refer to BEVEL BOX GEAR OIL LEVEL, CHECKING AND FILLING .