Seal, Between The Transmission And Bevel Box, Bevel Box Side

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing

-- Remove the bevel box. Refer to BEVEL BOX .

-- Pry out the seal on the bevel box using the pulling hook -T20143/1- or -T20143/2-.

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

-- Fill the area between the sealing lip and dust lip -arrow- halfway using sealing grease for seal -G 052 128 A1-.

Fig 2: Identifying Oil Seals Sealing Lips

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Lightly lubricate the outer circumference of the seal.

-- Install the seal all the way using the thrust piece -T10298-.

Fig 3: Identifying Sealing Ring Driven In As Far As Stop Using Thrust Piece T10298

Courtesy of VOLKSWAGEN UNITED STATES, INC.