Center And Rear Muffler, Separating

WARNING: This page is about a different variant/trim than selected.

NOTE:

A separating point has been provided in the connecting pipe for individual replacement of the center or rear muffler.

The separating point is marked by depressions around the circumference of the exhaust pipe.

Special tools and workshop equipment required

Procedure

WARNING:

To prevent injuries from metal shavings, wear protective goggles and protective clothing.

-- Separate the exhaust pipe at the separating point -arrow 2- using the chain pipe cutter VAS 6254 or pneumatic jig saw V.A.G 1523 A.

Fig 1: Positioning Clamping Sleeve At Side Markings Arrows

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Position the clamping sleeve -4- centrally at the end marks -arrows 1 and 3- when installing.

-- Install the clamping sleeve so that bolt end -arrow- does not project beyond the lower edge of the clamping sleeve.

Fig 2: Clamping Sleeve Location

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Install the exhaust system free of stress. Refer to EXHAUST SYSTEM, INSTALLING .

Tightening Specifications

Component		Nm
Clamping sleeve		25