Section 29 (2.0L - MULTIPORT Fuel Injection - Engine Code(S): BPY (As Of 05.2006))

• 24 MULTIPORT Fuel Injection (MFI)
  • Fuel Injection System, Servicing
    • Notes
    • Safety Precautions
      • Notes
      • Observe the following if test and measuring instruments are required during a test drive:
    • Clean Working Conditions
    • Technical Data
  • Components, Checking
    • Notes
    • Heated Oxygen Sensor Before Catalytic Converter, Checking Heater
    • Oxygen Sensor 1 After Catalytic Converter, Checking Heater
    • Mass Air Flow Sensor, Checking
      • Notes
      • Checking voltage supply
      • Checking electrical circuit
    • Throttle Valve Control Module, Checking
    • Engine Coolant Temperature Sensor, Checking
      • Notes
      • Testing if display is approx. - 40.0° C
      • Testing if display approx. 140.0° C
    • Intake Air Temperature Sensor, Checking
      • Notes
      • Testing if display approx. -40° C or approx. -46° C:
      • Testing if display approx. 140° C:
    • Engine Speed Sensor, Checking
    • Fuel Injector, Checking
    • Intake Flap Motor And Intake Manifold Runner Position Sensor, Checking
    • Fuel Pressure Sensor, Checking
    • Low Fuel Pressure Sensor, Checking
    • Fuel Pressure Regulator Valve, Checking
  • Functions, Checking
    • Notes
    • Heated Oxygen Sensor, Checking
    • Oxygen Sensor After Catalytic Converter, Checking
  • Engine Control Module
    • Notes
    • Voltage Supply, Checking
    • Engine Control Module, Removing And Installing
  • Additional Signals, Checking
    • Notes
    • Speed Signal, Checking
    • Can-Bus Terminal Resistance, Checking