Camshaft Adjustment Valve 1 -N205-

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing

-- Disconnect the connector -1-.

Fig 1: Identifying Camshaft Adjustment Valve 1 Connector, Wiring Harness & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Loosen the wiring harness -2- from the bracket.

-- Remove the bolt -3-.

NOTE:

Do not pull out the camshaft adjustment valve 1 by the connector.

-- Remove the bolts -arrows- and pull the camshaft adjustment valve 1 out of the housing.

Fig 2: Identifying Camshaft Adjustment Valve 1 N205 Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

NOTE:

The camshaft adjustment valve 1 as well as the housing must be free of dirt and contaminants.

Remove the new camshaft adjustment valve 1 from is packaging only prior to installation.

CAUTION:

-- Lubricate the seal with engine oil.

-- Carefully insert the camshaft adjustment valve 1 into the housing and press it perpendicular to the valve axis in by hand until it is seated.

-- Tighten the bolts to 4 Nm.

Further installation is in reverse order of removal.