LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (2.0L - Lubrication - Engine Code(S): BPY) >> 17 Lubrication >> Description And Operation >> Lubrication System Overviews >> Oil Pump With Balance Shaft Drive

Oil Pump With Balance Shaft Drive

WARNING: This page is about a different variant/trim than selected.
Fig 1: Lubrication System Components, Assembly Overview Part 2
GWWN17-10069Courtesy of VOLKSWAGEN UNITED STATES, INC.
  1. Chain Guard
  2. Chain
    • Mark the direction of travel (installed position) using a colored mark before removing.
  3. Alignment Sleeve
  4. Intermediate Plate
  5. Oil Pump with Balance Shaft Drive
    • Before installing, check to be sure both alignment sleeves are present for centering.
  6. Bolt
    • 9 Nm
  7. Cover
    • Prevents the engine oil from foaming up.
  8. Bolt
    • 40 Nm
  9. Bolt
    • 8 Nm
  10. Oil Intake Pipe
    • Clean the screen if it is dirty.
  11. O-ring
    • Always replace.
  12. Bolt
    • 15 Nm + 90° (1/4) additional turn.
    • Always replace.
    • Note the different length of the bolts. Refer to Figure.
  13. Outer Rotor
    • Check the contact surfaces for groove buildup.
    • The mark must be visible.
  14. Inner Rotor
    • Check the contact surfaces for groove buildup.
  15. Oil Pump Cover
  16. Chain Sprocket
  17. Bolt
    • 20 Nm + 90° (1/4) additional turn.
    • Always replace.
  18. Chain Tensioner with Tensioning Rail
  19. Bolt
    • 15 Nm
scientia non olet · About LEMON Manuals