Oil Pan
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 15 Nm
- Oil Dipstick
- Marks, refer to Figure.
- Oil level must not be above the MAX. mark!
- Inlet Spout
- Guide Tube
- Intermediate Plate
- Oil Pump with Balance Shaft Drive
- With a pressure relief valve of 12 bar.
- Removing and installing, refer to OIL PUMP WITH BALANCE SHAFT DRIVE .
- Bolt
- 15 Nm + 90° (1/4) additional turn.
- Always replace
- Note the different length of the bolts, refer to Figure.
- Bolt
- 15 Nm
- Bolt
- 8 Nm
- For the charge air pipe.
- Oil Pan
- Clean the sealing surface before installing.
- Removing and installing, refer to OIL PAN .
- Bolt
- 15 Nm
- Oil Drain Plug
- 30 Nm
- Always replace.
- With a permanent sealing ring.
- Chain Sprocket
- Bolt
- 10 Nm
- Not available in the US/Canadian market.
- Protective Cap
- Not available in the US/Canadian market.
- Oil Level Thermal Sensor -G266-
- Not available in the US/Canadian market.
- Seal
- Always replace.
- Lubricate before installing.
- Not available in the US/Canadian market.
- Bolt
- 20 Nm + 90° (1/4) additional turn.
- Always replace.
- Chain Guard
- Chain
- Sealing Flange
- Must be located on the alignment pins.
- Removing and installing, refer to SEALING FLANGE, BELT PULLEY SIDE .
- To remove and install, remove the oil pan. Refer to OIL PAN .
- Crankshaft seal, belt pulley side, replacing. Refer to CRANKSHAFT SEAL, BELT PULLEY SIDE .