Accelerator Pedal Module

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Release Tool T10238

Removing

-- Remove the steering column cover retainers -arrows- and cover.

Fig 1: Removing Steering Column Cover

GWWA20-1085

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Pry out the cap -3- with a screwdriver.

Fig 2: Accelerator Pedal Module, Connectors & Bolt

GWWN20-10509

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove the bolt -2-.

-- Disconnect the connector -1- -arrow- from the accelerator pedal module.

-- Slide the release tool T10238 as shown into the openings designated for it until it stops and remove the accelerator pedal module.

Fig 3: Installing Release Tool T10238

GWWN20-10056

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

-- Connect the connector -1- to the accelerator pedal module -4-. Lock the connector -arrow-.

Fig 4: Accelerator Pedal Module, Connectors & Bolt

GWWN20-10509

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Press the accelerator pedal module onto the retaining pins -5-.

-- Insert the centering pin -6- into the hole on the vehicle floor.

-- Secure the accelerator pedal module with the bolt -2- and install the cap -3-.

-- Install the cover on the steering column and install the retainers -arrows-.

Fig 5: Removing Steering Column Cover

GWWA20-1085

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tightening Specification

Component		Nm
Accelerator pedal module to body		10