Vehicle Electrical System Control Module -J519-
WARNING: This page is about a different variant/trim than selected.
NOTE:
If Vehicle Electrical System Control Module is to be replaced, the work procedure VEHICLE ELECTRICAL SYSTEM CONTROL MODULE -J519-, CODING to read out the codes stored in the module must always be performed.
Removing
Removal of Vehicle Electrical System Control Module matches removal of RELAY PANEL ON VEHICLE ELECTRICAL SYSTEM CONTROL MODULE, LEFT SIDE, INSTRUMENT PANEL .
Installing
Installation of Vehicle Electrical System Control Module matches installation of RELAY PANEL ON VEHICLE ELECTRICAL SYSTEM CONTROL MODULE, LEFT SIDE, INSTRUMENT PANEL .