Windshield And Headlamp Washer Fluid Reservoir Filler Neck

WARNING: This page is about a different variant/trim than selected.

Removing

-- Disconnect connecting tube -1- from filler tube -3- of tank for windshield washer system and headlamp cleaning system.

Fig 1: Identifying Filler Tube For Tank For Windshield Washer System And Headlamp Cleaning System Remove/Install Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove screw -2-.

-- Unclip hose retainer from filler tube -3- and remove filler tube -3- from vehicle.

Installing

Installation is performed in the reverse order of removal. Note the following:

Casting mark on under side of filler tube must be inserted into engine mounting hole -arrow-.

Fig 2: Identifying Casting Mark On Under Side Of Filler Tube And Engine Mounting Hole

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Connecting tube -1- and filler tube -2- must be joined so that the guides -arrows- engage in each other.

Fig 3: Identifying Tube And Filler Tube Joined So That The Guides Engage In Each Other

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.