Headlamp Washer Pump -V11-

WARNING: This page is about a different variant/trim than selected.

The headlamp washer pump is installed at tank for windshield washing system and headlamp cleaning system in right wheel housing.

Removing

-- Turn off the ignition and all electric consumers and remove the key.

-- Remove front bumper cover. Refer to Removal and Installation .

-- Remove headlamp washer pump -9- upward out of tank.

Fig 1: Identifying Windshield Washer System And Headlamp Cleaning System Tank Remove/Install Components - Vehicles Without Parking Heater

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect electrical connection -10-.

-- To disassemble connecting tube -8-, pull securing clip at connection and pull connecting tube -8- from headlamp washer pump.

Installing

Installation is performed in the reverse order of removal. Note the following:

-- Tighten all threaded connections to specified torques. Refer to TIGHTENING SPECIFICATIONS .

-- Bleed headlamp washer system after completing assembly work. Refer to HEADLAMP WASHER SYSTEM, BLEEDING .