Engine, Securing To Engine And Transmission Holder Vas 6095
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Engine Sling -2024 A-
- Shop Crane -VAS 6100-
- Engine and Transmission Holder -VAS 6095-
Secure the engine to the engine and transmission holder -VAS 6095- when working on it.
-- Separate the transmission.
-- Install the engine sling -2024 A- as follows and lift out the engine from the engine/transmission jack -V.A.G 1383 A- using the shop crane -VAS 6100-.
Belt pulley side: 2nd hole of rail in position 1.
Flywheel side: 1st hole of rail in position 7.
CAUTION:
Use securing pins at hook and drifts in order to prevent damage on engine and on vehicle.
- The peg positions on the engine sling marked 1 to 4 face the belt pulley.
- The bores in the hole rail are counted from the hook.
-- Secure the engine to the engine and transmission holder -VAS 6095-.