Vehicle Diagnosis Tester, Connecting, Golf My 98 Through My 03
WARNING: This page is about a different variant/trim than selected.
-- Apply the parking brake.
-- In vehicles with automatic transmission, move the selector lever to the "P" or "N" position.
-- In vehicles with manual transmissions, move the shift lever to the neutral position.
-- Remove trim -1- in direction of arrow.
-- With the ignition switched off, connect the Vehicle Diagnostic Tester with the diagnostic cable to the data link connector in the vehicle -arrow-.
Fig 1: Identifying Tester VAS 5051 Connected To Data Link Connector Using Diagnosis Cable VAS 5051/1
-- Switch on ignition.
-- Turn off all electrical consumers.
NOTE:
The connection of all other and the following diagnostic operation system or vehicle diagnosis and service system occurs in the previously described sequence.