Can Bus Wires, Repairing
WARNING: This page is about a different variant/trim than selected.
- Unshielded two-strand wiring -1- and -2- with a cross section of 0.35 mm2 or 0.5 mm2 can be used as CAN-Bus wiring.
- The color coding of CAN-Bus wires can be found in the following table:
| CAN High wire, Powertrain | orange/black |
| CAN High wire, Comfort | orange/green |
| CAN High wire, Infotainment | orange/violet |
| CAN-Low lead (all) | orange/brown |
- Repairs on CAN-Bus wires can be performed with repair wire with matching cross section and also with twisted wires "green/yellow" or "white/yellow".
- When repairing Bus leads, both wires must be of the same length. When twisting together wires -1- and -2-, length of lay of A = 20 mm must be observed.
- While doing this, no section of the wire, for example, in area of crimp connectors -arrow-, may be greater than B = 50 mm without twisting of the wires.
- Wrap repair points with yellow adhesive tape to mark a performed repair.