Round Connector Systems

WARNING: This page is about a different variant/trim than selected.

NOTE:

If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to SECONDARY LOCK .

-- Guide the release tool which fits the terminal housing into release channel on terminal housing.

Fig 1: Identifying Terminal At Wire Pushed Into Terminal Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Grasp contact at wire and push it gently into terminal housing -arrow-.

NOTE:

By pushing the contact in the direction of the terminal housing, the contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.

-- At the same time, push release tool in direction of terminal housing -arrow- and pull the released contact out of terminal housing.

-- After removing the contact, release tool can be pulled out of terminal housing again.

Fig 2: Identifying Released Terminal Pulled Out From Terminal Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.