LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Clutch - Manual Transmission 02Q) >> 30 Clutch >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different variant/trim than selected.
Component Fastener Size Nm
Clutch Pedal to Mounting Bracket Through Bolt Nut (1) - 25
Impact Bolster Support to Steering Column Bracket Bolt (1)
-- Secured with One Bolt - 20
-- Secured with Two Bolts - 10
Mounting Bracket to Bulkhead Nut (1) - 25
Pressure Plate to Dual Mass Flywheel Bolt (3)
  M6 13
M7 20
Slave Cylinder with Release Bearing to Transmission Bolt 1, 2
-- Without Locking Compound (slave cylinder with metal housings only) - 12
-- With Locking Compound - 15
(1) Always replace
(2) Carefully tighten diagonally and in small stages so that the slave cylinder bolt tabs do not break off
(3) Loosen and tighten in small steps and in a diagonal sequence
scientia non olet · About LEMON Manuals