Breather Assembly

WARNING: This page is about a different variant/trim than selected.

Removing and Installing the Line -4- to the Breather Assembly -1-:

Fig 1: Hose/Line Assembly Or Plastic Line On Breather, Removing And Installing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Pull the circlip -2- up with a screwdriver or a pointed tool and remove the line -4- from the breather assembly -1-.

-- Push the line -4- and O-ring -3- into the breather assembly -1- until the circlip -2- engages audibly.

-- Pull on the line to make sure it is secure.

Removing and Installing the Breather Assembly -4- from/to the Slave Cylinder:

Fig 2: Bleeder At Slave Cylinder, Removing And Installing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- To remove, pull the circlip -2- up with a screwdriver or a pointed tool and remove the breather assembly -4- from the slave cylinder -1-.

-- Check the O-ring -3- on the clutch slave cylinder. Press the breather assembly onto the slave cylinder connector until the circlip -2- engages audibly.

-- To check, pull on the breather assembly.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .