Clutch Overview, SACHS
WARNING: This page is about a different variant/trim than selected.
- Dual Mass Flywheel
- Removing and installing, refer to one of the following:
Gas engines, refer to Removal and Installation , [For engine(s) BPY] Removal and Installation , or [For engine(s) CCTA, CBFA] Removal and Installation .
- Make sure it fits securely on the alignment pins.
- Keep the clutch lining contact surface free of grooves, oil and grease.
- Removing and installing, refer to one of the following:
- Clutch Disc
- Only replace together with the pressure plate.
- Removing and installing, refer to CLUTCH, SACHS .
- Installed position, refer to Figure.
- Pressure Plate
- With the adjustment mechanism.
- Only replace together with the clutch disc.
- Removing and installing, refer to CLUTCH, SACHS .
- Check the ends of the diaphragm spring. Refer to Figure.
- Check the spring and rivet connections. Refer to Figure.
- Bolt
- M6 - 13 Nm
- M7 - 20 Nm
- Loosen and tighten in small steps and in a diagonal sequence.