Checking Measurement

WARNING: This page is about a different variant/trim than selected.

The selected adjusting shim is installed.

-- Install the measuring tools.

-- If there are protruding housing edges: place an 8 mm washer on the bolt -arrow- for the installation arbor VW 792 on the clutch housing.

Fig 1: Inserting Washers At Securing Bolt For Assembly Tool VW 792 At Clutch Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Set the dial gauge (3 mm range) with a 1 mm preload to "0".

-- Loosen the bolts for the clutch housing to transmission housing in a diagonal sequence until the bolts clear the transmission housing and output shaft.

-- For a correctly selected adjustment shim, the dial gauge must now display a value of 0.15 mm to 0.25 mm.