Adjustment Overview

WARNING: This page is about a different variant/trim than selected.

NOTE:

When performing repairs on the transmission, readjustment of the output shaft for 1st to 4th gears, output shaft for 5th/6th gear and reverse gears or differential is only required if components, which have a direct influence on transmission adjustment, have been replaced. Refer to table to avoid any unnecessary adjusting.

		To be adjusted:
		Output shaft, 1st to 4th gears, refer to OUTPUT SHAFT, 1ST TO 4TH GEARS, ADJUSTING	Output shaft, 5th, 6th and reverse gears, refer to OUTPUT SHAFT, 5TH, 6TH AND REVERSE GEARS, ADJUSTING	Differential, refer to DIFFERENTIAL, ADJUSTING
Replaced part:	Transmission housing	x	x	x
	Clutch housing	x	x	x
	Output shaft, 1st to 4th gears	x
	Output shaft, 5th, 6th and reverse gears		x
	Differential housing			x
	Output shaft tapered roller bearing, 1st to 4th gears	x
	Output shaft tapered roller bearing, 5th, 6th and reverse gears		x
	Differential tapered roller bearing			x