Selector Shafts And Forks, Installed Positions

WARNING: This page is about a different variant/trim than selected.

Fig 1: Installation Position Of Shafts And Selector Rods In Transmission

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Input shaft

2 - Output shaft, 1st to 4th gears

3 - Output shaft 5th/6th and reverse gear

4 - Reverse shaft

A - Selector shaft for 3rd and 4th gear

B - Selector shaft for 1st and 2nd gear

C - Selector shaft for 5th and 6th gear

D - Reverse gear selector fork ¹

¹ On some transmissions, the mounting for the reverse gear selector fork and the selector shaft for 5th and 6th gear - C- are different. Refer to Figure.