Cylinder Block And Components
WARNING: This page is about a different variant/trim than selected.
- Knock Sensor 1 -G61-
- To remove, the coolant thermostat housing must be removed. Refer to COOLANT THERMOSTAT HOUSING WITH THERMOSTAT .
- Contacts are gold plated.
- Bolt
- 20 Nm
- Tightening specifications affect function of knock sensor
- Knock Sensor 2 -G66-
- It is necessary to remove the oil filter bracket first in order to remove the knock sensor 2. Refer to OIL FILTER BRACKET .
- Contacts are gold plated.
- Wire Bracket
- Bolt
- Wire Bracket
- Bolt
- Gasket
- Always replace.
- Oil Filter Bracket
- Overview, refer to OIL FILTER BRACKET .
- Bolt
- 15 Nm + 90° (1/4) additional turn.
- Always replace.
- Intake Manifold Support
- Bolt
- Bolt
- 10 Nm
- Engine Speed Sensor -G28-
- Seal
- Always replace.
- Bolt
- 15 Nm
- Coolant Thermostat Housing with Coolant Thermostat
- Removing and installing, refer to COOLANT THERMOSTAT HOUSING WITH THERMOSTAT .
- O-ring
- Always replace.
- Bolt
- 40 Nm
- Accessory Bracket
- Bolt tightening sequence, refer to Figure.