Test-ID 165 ($A5): Misfire Cylinder 4 Data
WARNING: This page is about a different car, the 2008 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
-- Connect the scan tool.
-- Start the engine and let run at idle speed.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored ".
Select "Test-ID 165 ($A5)".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min./Max. Values | Additional Information | |
|---|---|---|---|---|---|
| 11 ($0B) | P0304 | Combustion misfires Cylinder 4 Average value over 10 Driving Cycles. For additional information, refer to the Bosch Motronic ME 7.1.1 OBD System Strategy. | 0 - 65535 (counts) | Refer to DTC P0304 in the SAE P0XXX DIAGNOSTIC TROUBLE CODES . | |
| 12 ($0C) | P0304 | Combustion misfires Cylinder 4 in this Driving Cycle. For additional information, refer to the Bosch Motronic ME 7.1.1 OBD System Strategy. | 0 - 65535 (counts) | Refer to DTC P0304 in the SAE P0XXX DIAGNOSTIC TROUBLE CODES . | |
-- If any of components or systems fail to meet the specified values. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition off.
End of Diagnosis