OBDMID $71 (113): Secondary Air Injection (AIR) System (Bank 1)
WARNING: This page is about a different car, the 2008 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
-- Connect the scan tool.
-- Start the engine and let run at idle speed.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored ".
Select "Test-ID 70 ($46)".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 129 ($80) | P0491 | Secondary Air Injection (AIR) system, bank 1 test for reduced secondary air mass flow check. For additional information, refer to the Bosch Motronic ME 7.1.1 OBD System Strategy. | 0.352 | 2 | Refer to DTC P0491 in the SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
| 130 ($81) | P2440 | Secondary Air Injection (AIR) system, bank 1 test for reduced secondary air mass flow check. For additional information, refer to the Bosch Motronic ME 7.1.1 OBD System Strategy. | 0 | 1.219 | Refer to DTC P2440 in the DTC table SAE P2XXX DIAGNOSTIC TROUBLE CODES P2440 . |
-- If any of components or systems fail to meet the specified values. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition off.
End of Diagnosis