Wiring Harness With 8 Pin Connector

Removing 

-- Remove the transmission pan. Refer to TRANSMISSION FLUID PAN .

-- Remove the fluid filter. Refer to TRANSMISSION FLUID FILTER .

-- Disconnect the connectors from the automatic transmission hydraulic pressure sensor 1 -G193- -1- and the automatic transmission hydraulic pressure sensor 2 -G194- -4-, if equipped.

Sensors -1 and 4- are not installed in every transmission.

Fig 1: Identifying Valve Body Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors -2 and 5-.

-- Replace the wiring harness or the transmission input speed sensor -G182- or the transmission output speed sensor -G195- if one of the connectors gets damaged.

-- Remove the bolt -6-.

-- Pay attention when attaching the bracket to the transmission fluid temperature sensor -G93- -7-.

-- Carefully remove the transmission fluid temperature sensor -7- together with the bracket from the valve body.

-- Disengage the wiring harness on the bracket -8-.

-- Disconnect the connector -1- from the transmission.

Fig 2: Identifying 8-Pin G68 and 14-Pin G93 Electrical Harness Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt from the 8 pin transmission connector.

-- Remove the connector and the wiring harness from the transmission housing.

Installing 

Install in reverse order of removal.

-- Replace the O-ring on the connector.

-- Push the connector all the way into the transmission.

-- Tighten the bolt for the 8 pin transmission connector. Tightening specification, refer to FASTENER TIGHTENING SPECIFICATIONS .

-- Tighten the bolts on the bracket for the transmission fluid temperature sensor. Tightening specification, refer to FASTENER TIGHTENING SPECIFICATIONS .

-- Install the fluid filter. Refer to TRANSMISSION FLUID FILTER .

-- Install the transmission pan. Refer to TRANSMISSION FLUID PAN .