LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Controls, Housing - 6-Speed Automatic Transmission 09G (As Of 04.2010)) >> 37 Controls, Housing >> Specifications >> Transmission To Engine Tightening Specifications

Transmission To Engine Tightening Specifications

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Tightening Torques, Transmission To Engine (Rabbit/GTI 2006 With 2.5L - 110 kW Engine, Tightening Torques)
GWWN37-10331Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. 1 -

    Driving Direction

  2. -

    Drive Plate to Converter

    • 60 Nm
    • Quantity: 6, remove and install using V/175.
  3. -

    M12 Bolts

    • 80 Nm
    • 65 Nm, if using T10179.
  4. -

    M10 Bolts

    • 40 Nm
    • The bolts are located in the lower flange
  5. -

    Two alignment sleeves inside the engine -arrows-

-- Make sure the bracket does not touch the ATF cooler.

Fig 2: Identifying Selector Lever Cable Retainer And Bolts
GWWN37-10203Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Nuts - 8 Nm

scientia non olet · About LEMON Manuals