Multifunction Transmission Range Switch -F125-: Adjusting

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into the "N" position.

-- Do not bend the selector lever cable.

Adjustment Prerequisites

Selector lever cable is disconnected at the selector shaft lever
The selector shaft is in the "N" position.
The bolts on the multifunction switch have been loosened.
The lever/selector shaft is removed.

Perform the following procedure:

-- Install the T10173 on the selector shaft -2- and turn the multifunction switch -1- just until the T10173 locks onto the tab on the connector on the multifunction switch.

Fig 1: Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the bolt -3- to secure the T10173 to the selector shaft -2-.

-- Tighten the bolts -arrows- to 6 Nm.

-- Remove the T10173.

-- Further installation is performed in the reverse sequence, refer to Installing .