LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (2.5L - Crankshaft, Cylinder Block - Engine Code(S): BGP, BGQ, CBTA & CBUA) >> 13 Crankshaft, Cylinder Block >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Accessory Bracket to Cylinder Block Bolt - 25
Air Conditioning Compressor to Accessory Bracket Bolt - 25
Air Conditioning Compressor Ribbed Belt Tensioner to Accessory Bracket Bolt - 35
Bracket to Cylinder Block Bolt - 25
Brake Booster Vacuum Pump to Control Housing Cover Bolt - 10
Connecting Rod Bearing Cap to Connecting Rod Bolt 1, 4 - 30 + 90°
Coolant Pipe Bolt/Nut - 10
Coolant Pump to Cylinder Block Bolt - 10
Cover Plate to Cylinder Block Bolt - 10
Crankshaft Bearing Cap to Cylinder Block Bolt (1) - 40 + 90°
Drive Plate/Flywheel to Crankshaft Bolt (1) - 60 + 90°
Engine Mount to Accessory Bracket Bolt - 40 + 90°
Engine Speed Sensor to Sealing Flange, Transmission Side Bolt - 5
Generator and Coolant Pump Ribbed Belt Tensioner to Accessory Bracket Bolt - 35
Intake Manifold Support/Oil Dipstick Guide Tube to Cylinder Block Bolt - 25
Knock Sensor to Cylinder Block Bolt (3) - 20
Locking Bolt to Cylinder Block - 30
Lower Idler Pulley with Bracket to Accessory Bracket Bolt - 25
Oil Filter Bracket to Cylinder Block Bolt - 25
Pressure Relief Valve - 27
Sealing Flange, Belt Pulley Side to Cylinder Block Bolt - 10
Sealing Flange, Transmission Side to Cylinder Block Bolt - 25
Thermostat Housing to Cylinder Block Bolt - 10
Upper Idler Pulley with Bracket to Accessory Bracket Bolt - 8
Vibration Damper Pulley to Crankshaft Bolt 1, 2   50 + 90°
(1) Always replace
(2) Only use a strength category 10.9 bolt
(3) Tightening specification affects the function of the knock sensor
(4) Lubricate the threads and contact surface