Ribbed Belt TENSIONER, A/C Compressor
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Note the following whenever working inside the engine compartment due to limited space:
- Route all lines and wires in their original locations.
- Ensure sufficient clearance to all moving or hot components.
-- Remove the ribbed belt. Refer to RIBBED BELT .
-- Loosen the bolt -2- for the belt tensioner -1- and remove the tensioner.
-- Install in reverse order of removal. Note the following:
Tightening Specification
| Component | Nm | |
|---|---|---|
| Belt tensioner to accessory bracket | 35 | |