Input Shaft, Output Shafts, Differential And Shift Forks
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input Shaft, Output Shaft (Pinion Shaft), Differential And Shift Forks, Removing And Installing, Overview
- Differential
- Disassembly and assembly, refer to DIFFERENTIAL .
- Seal
- Quantity: 4
- Always replace.
- Output Shaft
- Disassembly and assembly, refer to OUTPUT SHAFT .
- Reverse Gear Shaft Support
- Disassembly and assembly, refer to REVERSE SHAFT .
- Reverse Shaft
- Disassembly and assembly, refer to REVERSE SHAFT .
- Input Shaft
- Disassembly and assembly, refer to INPUT SHAFT .
- Reverse Gear Selector Fork
- Disassembly and assembly, refer to SELECTOR FORKS .
- Installed position refer to "Assembly" in the TRANSMISSION .
- TORX® Bolt
- 25 Nm
- Selector Fork with Rail
- Disassembly and assembly, refer to SELECTOR FORKS .
- Clutch Housing
- Disassembly and assembly, refer to TRANSMISSION AND CLUTCH HOUSINGS .
- Nut
- 25 Nm + 90° (1/4) additional turn.
- Always replace.
- 4 nuts, for the output shaft bearing support.
- Flange Shaft with Pressure Spring
- Removing and installing, refer to one of the following:
- Assembling, refer to DIFFERENTIAL .
- Bolt
- 25 Nm