Shift Knob, Boot And Cover
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
- Emblem
- Can be carefully pried out of a plastic or leather shift knob using the trim removal wedge 3409.
- Shift Knob
- With the boot.
- The shift knob and boot cannot be separated from each other. Always replace them together.
- Removing and installing, refer to SHIFT KNOB, BOOT AND COVER .
- Clamp
- For securing the shift knob to the shift lever.
- Attach to the shift knob using the hose clamp pliers V.A.G 1275
- Always replace.
- Center Control Cover
- Combined in one piece with the upper center console section on some versions.
- Noise Insulation
- Not installed on all vehicles.
- The arrow on the noise insulation points in the direction of travel.
- The retaining tab spacing varies. Therefore, can only be installed in one position.