LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Controls, Housing - 5-Speed Manual Transmission 0A4 (As Of 06.2011)) >> 34 Controls, Housing >> Description And Operation >> Selector Forks Overview

Selector Forks Overview

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The selector fork group (-item 7-) does not need to be disassembled to remove and install shift segments, lock washers and angular contact ball bearings.

Fig 1: Exploded View Of 5th Gear Shift Fork
GWWN34-1702Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. 5th Gear Shift Segment
    • Identification, refer to Figure.
    • The shift segment must still rotate easily after the lock washer is installed.
  2. Lock Washer
    • Always replace.
    • Removing, refer to Figure.
    • Installing, refer to Figure.
  3. 5th Gear Selector Fork
  4. Bolt, 25 Nm
  5. 5th Gear Shift Jaw
  6. Angular Contact Ball Bearing
    • Quantity: 4
    • Removing, refer to Figure.
    • Pressing the bearing inner race into the outer race. Refer to Figure.
    • Installing, refer to Figure.
  7. Selector Fork with Rails
  8. 1st/2nd Gear Shift Segment
    • Identification, refer to Figure.
    • The shift segment must still rotate easily after the lock washer is installed.
  9. 3rd/4th Gear Shift Segment
    • Identification, refer to Figure.
    • The shift segment must still rotate easily after the lock washer is installed.
  10. Gliding Piece
  11. Spring
  12. Reverse Gear Selector Fork
  13. Support for the Reverse Gear Selector Fork
  14. Locking Ring
scientia non olet · About LEMON Manuals