Leak Detection Pump -V144-

WARNING: This page is about a different car, the 2009 Volkswagen GTI and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the right rear wheel housing liner. Refer to FRONT WHEEL HOUSING LINER .

-- Disconnect the vacuum line -1-.

Fig 1: Identifying Leak Detection Pump (LDP) V144 Electrical Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Disconnect the connector -2-.

-- Disconnect the vent line -3- by pressing release button.

-- Remove the nuts -arrows-.

-- Disengage the leak detection pump with bracket.

Installing

Installation is performed in the reverse order of removal, noting the following:

The vent line -3- must engage audibly.

-- Install the right rear wheel housing liner. Refer to FRONT WHEEL HOUSING LINER .