Accelerator Pedal Module

Special tools and workshop equipment required 

• Release Tool -T10238-

Removing 

-- Remove the steering column cover retainers -arrows- and cover.

Fig 1: Identifying Steering Column Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Pry out the cap -3- with a screwdriver.

Fig 2: Identifying Accelerator Pedal Module, Connectors & Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove the bolt -2-.

-- Disconnect the connector -1- -arrow- from the accelerator pedal module.

-- Slide the release tool -T10238- as shown, into the openings designated for it until it stops and remove the accelerator pedal module.

Fig 3: Installing Release Tool T10238

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

-- Connect the connector -1- to the accelerator pedal module -4-. Lock the connector -arrow-.

Fig 4: Identifying Accelerator Pedal Module, Connectors & Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Press the accelerator pedal module onto the retaining pins -5-.

-- Insert the centering pin -6- into the hole on vehicle floor.

-- Secure the accelerator pedal module with the bolt -2- and install the cap -3-.

-- Reinstall the steering column cover and retainers -arrows-.

Fig 5: Identifying Steering Column Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tightening Specifications