Selector Shaft Seal

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Thrust Piece -T10174-

Removing

-- Remove the multifunction transmission range switch -F125-.

-- Carefully pry out the selector shaft seal with a screwdriver. Be careful not to damage the selector shaft when doing this.

Installing

Install the new seal using the thrust piece -T10174-. Do not tilt the seal.

Fig 1: Identifying Thrust Piece T10174 To Drive-In New Gasket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Adjust the multifunction transmission range switch. Refer to Multifunction Transmission Range Switch -F125-, ADJUSTING .