LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (2.0L - Engine Assembly - Engine Code(S): CBFA & CCTA) >> 10 Engine Assembly >> Description And Operation >> Engine And Transmission Mount Overview

Engine And Transmission Mount Overview

WARNING: This page is about a different car, the 2009 Volkswagen GTI and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Assembly Overview: Engine And Transmission Mount
GWWA10-10623Courtesy of VOLKSWAGEN UNITED STATES, INC.
  1. Bolt 
    • Tightening specifications, refer to one of the following:
      • GTI, Eos, Passat and CC with a Direct Shift Gearbox (DSG R), refer to SPECIFICATIONS .
      • GTI, Eos, Passat and CC with a manual transmission, refer to SPECIFICATIONS .
      • Passat and CC with a automatic transmission, refer to SPECIFICATIONS .
    • Transmission mount bracket to transmission.
  2. Bolt 
    • Tightening specification. Refer to SPECIFICATIONS .
    • Pendulum support to transmission.
  3. Engine Mount Bracket 
  4. Bolt 
    • 40 Nm + an additional 180° (1/2) turn.
    • Always replace.
    • Engine mount bracket to engine.
  5. Engine Mount 
  6. Bolt 
    • 40 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Engine mount to body.
  7. Support 
  8. Bolt 
    • 20 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Support to engine mount.
  9. Bolt 
    • 20 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Support to body.
  10. Bolt 
    • 40 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Engine mount to body.
  11. Bolt 
    • 60 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Engine mount to engine mount bracket.
  12. Pendulum Support 
  13. Bolt 
    • 100 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Pendulum support to subframe.
    • First, install the pendulum support to transmission bolt, then install the pendulum support to subframe bolt.
  14. Bolt 
    • 60 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Transmission mount to transmission mount bracket.
  15. Bolt 
    • 40 Nm + an additional 90° (1/4) turn.
    • Always replace.
    • Transmission mount to body
  16. Transmission Mount 
    • The illustration shows the DSG R version.
  17. Bolt 
    • Tightening specifications, refer to one of the following:
      • GTI, Eos, Passat and CC with a DSG R, efer to SPECIFICATIONS .
      • GTI, Eos, Passat and CC with a manual transmission, refer to SPECIFICATIONS .
      • Passat and CC with a automatic transmission, refer to SPECIFICATIONS .
    • Transmission mount bracket to transmission.
  18. Transmission Mount Bracket 
scientia non olet · About LEMON Manuals