Crankshaft Oil Seal, Flywheel Side

WARNING: This page is about a different car, the 2008 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Assembly tool T10122
Pulling hook T20143

Removing

-- Install the T20143/2 behind the sealing lip of the oil seal as shown in the illustration.

Fig 1: Identifying Removal Hook T20143/2 Placed Behind Sealing Lip Of Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Support the T20143/2 on the sealing flange and pry out the seal in the -direction of the arrow-.

Installing

-- Pull the seal -A- with the outer side over the T10122/1 onto the T10122/2.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Separate both assembly sleeves.

-- Install the T10122/2 with a dry seal onto the crankshaft end.

-- Install the seal into the sealing flange until seated using the T10122/3.

Fig 3: Driving Seal Into Sealing Flange Until Stop Using Thrust Piece T10122/3

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.