LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (2.0L - Turbocharger, Supercharger - Engine Code(S): CBFA & CCTA) >> 21 Turbocharger, Supercharger >> Removal And Installation >> Charge Air Pipe To Noise Generator

Charge Air Pipe To Noise Generator

WARNING: This page is about a different car, the 2009 Volkswagen GTI and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Removing 

-- Remove the cover for the air guide, disengage the clips -arrows- to do so.

Fig 1: Identifying Air Duct Cover Slide Clips
GWWA10-10367Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Unclip the lower air guide, disengage the clips -arrows- to do so.

Fig 2: Identifying Lower Air Guide Clips
GWWA10-10368Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove both the lower air guide and the air guide hose.

-- Open the latch -1-, unclip the fuel lines -2- and loosen the bolts -3-.

Fig 3: Identifying Latch, Fuel Lines And Bolts
GWWN21-10197Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Loosen the clamp -arrow- and remove the charge air pipe.

Fig 4: Identifying Clamp To Charge Air Pipe
GWWN21-10198Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

Installation is performed in reverse order.