LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (2.0L - Cooling System - Engine Code(S): CBFA & CCTA) >> 19 Cooling System >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2009 Volkswagen GTI and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
After Run Coolant Pump Bracket to Bracket Bolt - 8
After Run Coolant Pump Bracket to Upper Oil Pan Bolt - 40
Connecting Piece to Coolant Pump Bolt - 9
Coolant Expansion Tank Bolt - 5
Coolant Fan to Fan Shroud Nut - 10
Engine Coolant Temperature Sensor Retaining Plate to Coolant Pump Bolt - 4
Fan Shroud to Radiator Bolt - 5
Front Coolant Pipe Bolt - 3.5
Radiator to Charge Air Pipe Bolt (3) - 5
Small Coolant Pipe Bolt - 9
Toothed Belt Drive Gear to Balance Shaft Bolt 1, 2 - 10 + 90°
Toothed Belt Guard to Coolant Pump Bolt - 9
(1) Always replace
(2) Has left hand threads
(3) Eos, GTI, Passat and CC only

Coolant Pump Bolt Tightening Sequence and Specification 

Fig 1: Identifying Coolant Pump Tightening Sequence
GWWA19-10458Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Tighten the bolts in sequence -1 through 5- to 9 Nm.

scientia non olet · About LEMON Manuals