LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (2.0L - Exhaust System, Emission Controls - Engine Code(S): CBFA & CCTA) >> 26 Exhaust System, Emission Controls >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2009 Volkswagen GTI and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Clamping Sleeve Nut
-- Individual Clamp - 25
-- Continuous Clamp - 35
Front Exhaust Pipe with Catalytic Converter to Exhaust Manifold/Turbocharger Nut 1, 4 - 40
Oxygen Sensor - 55
Suspended Mount Bracket Bolt (2) - 20
Secondary Air Injection Pump Motor Bracket to Underbody Nut (3) - 25
Secondary Air Injection Pump Motor to Bracket Nut (3) - 9
Secondary Air Injection Solenoid Valve Bolt (3) - 9
Suspended Mount to Subframe Bolt - 25
Suspended Mount to Underbody Bolt - 25
Tunnel Bridge to Underbody Bolt - 25
(1) Always replace
(2) Tiguan
(3) Engine code CBFA only
(4) Lubricate the stud bolts on the exhaust manifold/turbocharger with hot bolt paste -G 052 112 A3-
scientia non olet · About LEMON Manuals